.................................. Return to Sumner's Home Page....

Return to N Scale RR Main Menu........ Return to HandCab Menu

=========================================

..............Previous Page..............................Next Page If There Is One

=========================================

…....................--- Printing and Print File Links ---

.............--- Print files on thingiverse.com ( HERE ) ---

=========================================

NOTE: If you are printing or having a print service print the parts using a resin printer they need to be printed with a resin that 'is not brittle' as a number of the parts will need to be drilled, tapped and need to be strong. I use Siraya Tech 'Build' Sonic Gray and highly recommend it works. It can be drilled, tapped, has great detail and isn't brittle. I use it for even small parts that have a lot of detail. It is basically the only resin I use as it works so well regardless of the application.

Also if you have a printing service print make sure they are keeping the wall thicknesses on the parts as designed. You don't want parts like the handles hollowed out to save a buck or two.

Above are all the main parts minus three small brackets that will be shown later. The case top, middle and bottom were printed on an Ender 3 Pro filament printer with the control stand pieces printed with an AnyCubic Photon M3 resin printer. You could probably print all with either printer. I did it this way as I didn't need supports for the main case parts and using supports made the resin prints easier to setup and print.

Following are images from designing with Fusion 360.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

Some pictures of a finished HandCab.

.

.

.

.

.

.

.

Print files on thingiverse.com ( HERE ).

For the whole build of this throttle go ( HERE ).

=========================================

...........................On..............e.........Next Page If There Is One