..................................
Return
to Sumner's Home Page....
Return
to N Scale RR Main Menu........ Return
to Servo Control Menu
=========================================
.............................Turnout
Control/Switch Box Menu..............
=========================================
…...---
Turnout Control/Switch Box and Tops for It ---
=========================================
Bottom
of the box and tops were designed to hold the toggle switch,
push-button switch, LED's and wiring that you use at the edge of the
layout. I started with rectangular boxes and tops but then switched
to the current square ones. The advantage of the square ones is that
if you are ganging boxes together to create a control panel you can
turn the boxes and put them next to one another in any fashion as all
the sides are the same length.
Above
one can see the original boxes and some of the different options for
the tops of the boxes that can be printed out. Again you don't need
to use these boxes. You could design a control panel and put the
holes in it for the switches and LED's. I did the boxes and tops for
my layout and they will probably take the place of a more traditional
control panel. Some will be ganged together in a control panel
configuration and others will be place wherever needed along the side
of the layout by themselves or in groups as needed.
Next
you will find the bottom of the box and the different top options
printable at this time. You can find the print files on my
thingiverse account ( HERE
).
The
bottom of the box above is designed with a number of ways for you to
route the wires to it from the power supply and on to the servo
controller (side ends, bottom and both ends).
If
you gang boxes together you might need a box without a top that has
the holes for the switches and LED's. If so use the one above. Also
you have ….
….
the option for tops that show a straight route or ….
…..
a diagonal route.
Use
the one above and the next one for straight Left-hand and Right-hand
turnouts.
.
Above
and a number of the next tops are designed if you have curved
turnouts on the layout and there are options for the route that ends
up on the diagonal being either the main route or the divergent
route. Routes ending on the diagonal help in ganging boxes together
where one or more of the routes end up being on a corner verses being
in the middle of the top.
.
.
.
.
.
.
.
There
are also two tops that are designed to represent yard ladders, the
one above and the next one.
.
I
hand-laid some 3-way turnouts so made the top above that fits on two
bottoms. I could of also used a straight LH and RH top on adjoining
boxes.
Above
are 4 of the tops after being printed on the Ender 3 Pro. I'm using
'Standard Quality' for these vs. the 'High Quality' I normally use to
speed up the print time.
You
can find the print files for the box bottom and the tops ( HERE
).
=========================================
...........................On..e.........
Turnout
Control/Switch Box Menu