.................................. Return to Sumner's Home Page....

Return to N Scale RR Main Menu.............. Return to Locomotive Menu

=========================================

..............Previous Page..............................Next Page If There Is One

=========================================

…........--- .010 Guitar String – 1.6” N Scale Handrails ---

Using guitar strings for N scale handrails came up on one of the forums ( HERE ) and got my attention so thought I'd try it. They are cheap at $10 for 6 (.010 “) strings and those will do quite a few locos. I was thinking I'd solder the handrails together but couldn't get solder to stick to the wire using my favorite rosin flux and rosin core solder. As a result I used super glue to build the left side handrails. It worked pretty well and I'd recommend this for anyone who hasn't done a fair amount of soldering. It also was surprisingly strong.

Then someone mentioned using an acid flux to tin the wires and to solder the joints together. I realized that the flux I'd gotten from Fast Tracks was an acid flux so tried it. Spread the flux on the wire and it is easy to tin the wires and to solder the joints, well easy to tin the wire and relatively easy as far as soldering the joints.

The guitar string I used is Ernie Ball Custom Gauge 10 (1010). There are a lot of different types/brands out there if you want to try something different.

.

.

.

I can't stress enough the importance of keeping the tip clean and tinned while making these small solder joints. I keep the iron on the highest setting and get in and out of soldering the joint in less than a second. More soldering tips and the iron I use ( HERE ).

.

I built these handrails over two days and probably have at least 4 hours in them total but a fair amount of that was experimenting, learning and the two steps forward and one back deal. I also used about twice as much wire as needed with some of the mistakes and it shooting across the room when I cut it. I could probably do them again in say 1 ½ hours total start to finish after developing a method.

For the most part I like working with the guitar strings. They are easy to bend with needle nose pliers and your hand and hold any shape you shape them to once bent. Once I started using the acid flux the soldering went smoothly.

For tools I'd recommend small pliers and a small cutter. The pliers need to be smooth on the inside faces. If they have the grooves that help hold something the .010 wire will slip out of them laying in those grooves. A small needle nose with smooth inside faces is good along with a small rounded tip needle nose that will be better for doing the rounded bend at the front of the side rail and front/rear handrails. If you have an old pair of rail cutters or equivalent wire cutters you might try them but I found mine wouldn't cut the wire. I used a small pair of diagonal cutters that are beefier in the cutting face area. I just ordered a set of tools ( HERE ) that I think will be pretty much what I have now with the addition of the rounded needle nose and a smooth face wider plier. You can find cheaper sets and might already have what you need like I did to the most part but if you are like me an excuse for more tools is always good.

.

.

You can find the decoder install starting ( HERE ) and a YouTube with the engine running ( HERE ) or by clicking on the image above.

=========================================

…..............................................Next Page If There Is One