.................................. Return to Sumner's Home Page....

Return to N Scale RR Main Menu........... Return to Building UP's Canyon Division Menu

=========================================

...............Previous Page.............................Next Page If There Is One

=========================================

…..............................--- Sawmill Design/Build – Part 21 ---

…..............--- Saw Blade Sharpening Station ---

=========================================

You can find the print files for the 'sharping station' on thingiverse ( HERE ).

=========================================

This is a N scale sawmill bandsaw sharpening station that I loosely modeled off the one at the Hull-Oakes mill from pictures and the video ( HERE ).

This is the smallest design I've done so far and the print is tricky to support and hard to remove the supports without breaking anything. Also hard to get the last small pieces of the resin supports off the print. Again I used an AnyCubic Photon M3 ($200) printer and Siraya Tech 'Build' Sonic Gray resin. The resin gives good detail, is strong and the blade has flex to it.

.

.

.

.

.

.

.

.

.

.

I didn't have any measurements of the sharpening station or blade so used what seemed reasonable and what I thought would actually print and be viable .

.

=========================================

You can find the print files for the 'sharping station' on thingiverse ( HERE ).

=========================================

A link to this whole build ( HERE ).

=========================================

...........................On..............e.........Next Page If There Is One