.................................. Return to Sumner's Home Page....

Return to N Scale RR Main Menu........... Return to Building UP's Canyon Division Menu

=========================================

..............Previous Page..............................Next Page If There Is One

=========================================

….......--- Build Track Elevator Part 4 ---

============================================

NOTE: More about the track elevator on the first page of the build ( HERE ). If you haven't read about it the following will make more sense if you go back and take a couple minutes to see how I hope it works.

============================================

This page shows the building of the two movable walls inside the box enclosure. They have been used as it would have been hard to build the box to tight tolerances where the elevator just fit inside the box with the rollers right up against all four walls. In this design 2 of the four walls are fixed and the two walls opposite them can move in and out. With the elevator in the box and up against the fixed walls the movable walls can be pushed snug against the rollers for a close wit with no slop as the elevator goes up and down.

.

The elevator rollers will ride up and down the particle board which is smoother than the CDX plywood.

.

.

.

.

.

.

To be continued ......

=========================================

...........................On..............e.........Next Page If There Is One